If you are using your Cisco Catalyst switches to insert DHCP Option 82 information and you are also using your Cisco routers as DHCP relay-agents (via 'ip helper-address'), you'll notice right away that your Option 82 enabled DHCP requests are not being forwarded by your routers.

Cisco Systems, Inc.As a security measure, Cisco IOS will not forward DHCP requests that contain Option 82 information and a gateway request set to all zeroes. This is the condition of an initial DHCP request that has been rewritten by a Cisco Catalyst switch.

To globally enable these packets to transit all router interfaces, issue the 'ip dhcp relay information trust-all' in configuration mode. If you'd like to maintain this security feature and only trust these requests on certain interfaces, you can issue an interface specific command as seen in the configuration sequence below.

SLAP#configure terminal
Enter configuration commands, one per line.  End with CNTL/Z.
SLAP(config)# interface FastEthernet 0/0
SLAP(config-if)# ip dhcp relay information trusted
SLAP(config-if)#^Z
SLAP#write memory 
Building configuration...
[OK]
SLAP#

Once you've enabled trust for some or all interfaces, your Option 82 enabled DHCP requests should once again be relayed by your Cisco routers.

As always, if you have problems or questions, let me know.

Related Reading: