Posted on in Networking
If you are using your Cisco Catalyst switches to
insert DHCP Option 82 information
and you are also using your Cisco routers as DHCP relay-agents (via ip helper-address),
you'll notice right away that your Option 82 enabled DHCP requests are not being
forwarded by your routers.
As a security measure …
Posted on in Networking
If you've ever needed to reset a Cisco Catalyst switch to it's factory default (locked out, perhaps?), you've probably spent some time digging around on Cisco's web site. The Catalyst password recovery procedure starts off by reseting the Catalyst to it's original factory settings. Below, I'm going to give you …
Posted on in Networking
If you're interested in DHCP Option 82 in your Cisco Catalyst-based network, you'll be happy to know that the configuration can be summed up in 4 easy steps.
ip dhcp snooping. Although we're only turning this on to get …Posted on in Networking
How many times has this happened to you?
SLAP#write memory
startup-config file open failed (Device or resource busy)
If you work in an environment where multiple users have enable access on Cisco devices, you've probably seen it more than once. This particular error is caused when another user has …
Posted on in Networking
DS3 (also known as T3) scrambling is not an issue that comes up very often. It's something every network administrator should know about, though. After all, it just might save your bacon.
Some physical layer protocols depend on the transition from 1 to 0 in a frame to maintain clocking …
Posted on in Networking
Most network administrators should be familiar with Spanning Tree Protocol (STP; IEEE 802.1D). <acronym title="Spanning Tree Protocol">STP</acronym> is tasked with ensuring there are no loops in a bridged network. Unfortunately, STP is an older protocol and doesn't quite mesh with today's high speed networks. Here are …
Posted on in Networking
Is your network bandwidth being consumed by Peer-to-Peer (P2P) traffic? (Hint: If you don't know, it's time to fire up NBAR and do a little investigating.) One way to stop P2P traffic is to use an access-list to block traffic on the well-know P2P ports. Unfortunately, many P2P technologies no …
Posted on in Networking
I recently wrote about using Cisco's NBAR to investigate what protocols were in use on your network. I thought it might be interesting to take a look at the top 10 protocols on a residential broadband network. If you're running a large network, or planning a large network, perhaps this …
Posted on in Networking
The following is a list of alarms you may receive on your T1 or T3 (or E1/E3) interface. Where applicable, troubleshooting hints are included.
A Loss of Signal (LOS) alarm indicates that the interface is not receiving a valid T1 or T3 signal. This is …
Posted on in Networking
In a Metro Ethernet network, the possibility exists for a lot of NetBIOS broadcasts if your users are connecting directly to the ring rather than through a firewall. My first assumption was that most users would have a firewall, but this is really only guaranteed in the case of business-class …
