Posted on in System Administration
Configuring your syslog server to accept logging output from your Cisco routers and switches requires a few basic steps. We'll assume that you are using a new server and haven't made any previous changes to the syslog configuration. I use <acronym title="Red Hat Enterprise Linux">RHEL</acronym> 5 most …
Posted on in Networking
When setting up a Cisco ASA or PIX to send logs to a remote syslog server, you need to specify which facility to use. This can cause a bit of disconnect since the syslog server configuration uses names and the logging facility command in the Cisco Adaptive Security Appliance Software …
Posted on in Networking
Sending log messages from your Cisco network equipment to a centralized syslog server is a fairly normal activity. Most of the time, this setup works fine and there's no reason to do anything out of the ordinary. Occasionally though, you might need to run a debugging session over an extended …
