Articles tagged with fax

1. Rewriting FAX= Recepient Address with Sendmail

   Posted on February 03, 2010 in System Administration

   Previously, I mentioned that I was unable to remove the FAX= portion of the string produced by Cisco's $s$ (or $d$) macro in a T.37 store and forward fax configuration. That's still the case. I have found no way of doing this inside IOS. If it's possible, I've …

2. T.37 Store and Forward Fax and Cisco AS5300: Questions

   Posted on January 29, 2009 in voice

   Note: This is part of a discussion regarding the configuration of a Cisco AS5300 for T.37 Store and Forward Faxing.

   I haven't touched this series in a while, but I thought it might make sense to add a post that addresses common questions. If you have questions that aren't …

3. T.37 Store and Forward Fax and Cisco AS5300: Dial Peers

   Posted on January 09, 2008 in voice

   Note: This is part of a discussion regarding the configuration of a Cisco AS5300 for T.37 Store and Forward Faxing.

   The final piece of the T.37 Store and Forward Fax configuration is the dial peers to handle the incoming fax and the outgoing email. I'll walk you through …

4. TCL Onramp Script for T.37 Store and Forward Fax

   Posted on January 08, 2008 in voice

   Note: This is part of a discussion regarding the configuration of a Cisco AS5300 for T.37 Store and Forward Faxing.

   Unfortunately, the Cisco AS5300 does not have the ability to handle incoming fax processing without the help of additional software. You can download the app_faxmail_onramp TCL script from the …

5. T.37 Store and Forward Fax and Cisco AS5300: MTA and General Setup

   Posted on January 07, 2008 in voice

   I was recently engaged to configure a fax-to-email solution using a Cisco AS5300 and Asterisk. My original idea was to compile spandsp into Asterisk and use the RxFax() application to receive faxes. Everything seemed to work OK on the Asterisk side, but I had a lot of trouble with incoming …